The network transmission speed is always the hot topic which everybody pays attention, the same equipment actually presents the poles apart in the different place of use the effect, is this also because of what? Actually this is not strange, the network transmission speed receives the aspects factor the restriction. Today we together discover these restrictions with everybody, lets the network transmission speed dash!
First, manufacture standard mesh wire
As a result of each network company's constructors quality good and evil intermingled, this causes these experience quite low constructors can only satisfy “pass” the lowest request, they thought that the network can pass is qualified. Actually, the manufacture network line cable whether meet standards will have the direct influence to the network transmission speed. Now many intelligent switchboards, to the mesh wire both sides' manufacture standard can the automatic diagnosis, but considered from the standard angle, if an end continually network card equipment, another end continually switchboard and route equipment, then the both sides should defer to T568A or the T568B standard manufacture; What if both sides connection is the same type equipment, then must an end use T568A, another end uses T568B the standard, namely usually called line of intersection. Uses the standard the standard manufacture, may guarantee that the network signal does not receive disturbs, raises the network transmission speed effectively.
Second, lets the transmission line not disturb
When mesh wire's quality is bad, in addition receives other equipment's disturbance, then in this case the network transmission speed will slow down. The common situation for example uses the inferiority five kind of lines, then with the supply line, the communication link places in a pipeline to pass through, or approaches the water back uniform temperature high place, will like this cause equipment's work stability to produce fluctuates greatly. Therefore, our correct procedure should when the construction network pays attention to line's trend with the signal disturbance; Avoids other equipment in the concrete use process approaching for a long time, thus forms the good use habit, causes the network the transmission not the outside signal disturbance.
Third, network card full-duplex matched pattern
Network card's work has many kinds of patterns, but under the full-duplex pattern the transmission speed is quickest, but the present network termination many are the 10/100M auto-adapted network card, very easy to cause the network card work not under the full-duplex pattern. Regarding this kind of situation, we must the handwork suppose it are 100,000,000,000,000 full-duplex patterns.
Opens network card's attribute window, in the item cuts “high-level” the label in “the disposition”, then found “Link Speed/Duplex Mode” or “the link speed and the duplex” the item, at this time you will discover that it “the value” was generally “the automatic detection”, supposed it is “the 100Mbps/full-duplex” then. Like this lets the network card beginning open under 100,000,000,000,000 full-duplex patterns works, then the transmission speed will be higher than many.
Other pages: : 1 * 2 * Next>>
|
You are here: hacking technology
> network management
> Content
Category: Home
> network management