Windows 7 VMware wireless network in virtual machine Settings

By default, the virtual network adapter use VMware Workstation in 192.168.254.0 range - 192.168.1.0 (subnet mask for 255.255.255.0) two segment of the network card (corresponding to the first one VMnet1 and second nic VMnet8). Because the segment every card use is random, are not fixed. VMware doing network experiment in use, it is not convenient to use VMware, generally the segment in a certain range of fixed.

The machine configuration: Dell laptop, Windows7 Chinese system, virtual machine Windows server 2003 Chinese SP2

My network adapter below

Dell Wireless 1397 WLAN Mini - hello

Insgroupsto WiFi Adapter Miniport navigator

PCIe controller Realtek't FE

Successful networking premise:

First, the device manager inside VMware Ethernet Adapter order to have VMwareVirtual Ethernet Adapter VMnet1 and seas. VMnet8 (you only need 8, don't need 1 too). And shows no signs of problems. (if not installed correctly display, need to repair the vm, if install oracle virtural box to install the vm will appear this problem)

Secondly, the control panel network and Internet network connections inside, your nic attribute inside, VMware Bridge

Protocol agreement (note that is you need? Check the physical nic, not virtual LAN properties, virtual network adapter can not tick) as shown in figure 3

In addition, the system services that don't change the default renewal VMware started three essential services.

If the above set has a problem, as long as necessary to run the installer, choose repair installation, general problems can be solved.

Virtual machine networking detailed steps: (the following Settings are best used an administrator running)

1, open the start menu, all program, VMware, a insgroupsto Editor

2, open NAT tag page, put VMnet Host dropdown menus down, VMnet8 set as the Gateway IPAddress below, for example I is 192.168.32.2

3 and open DHCP tag page, choose the following list of VMnet8, and click on the lower right corner of the list IPAddress Properties button, write down Start and End, say my IP is after 192.168.32.128 and 192.168.32.254

4, closed a VMware, Editor, VMwareWorkstation insgroupsto run Virtual machine, change the hardware, setting nic operation mode for the second (NAT: to the host country now. IPaddress 's

5, start, virtual machine, for example say me to Windows server 2003 Chinese, and open the control panel network and Internet connection network connections

6, change the local connection properties inside the TCP/IP properties, choose to use the following the IP address, among them, the IP address fill just two DHCP page down inside the literally an IP IP address, i.e. from 192.168.32.254, literally 192.168.40.128 to choose a, I picked the 192.168.32.202. Subnet mask is automatically fill the 255.255.255.0, the default gateway and the following DNS is filling just NAT page down IP, such as my is 192.168.32.2.